Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: SamCec on October 26, 2010, 02:21:19 pm

Title: Thanks Grampa for your Help
Post by: SamCec on October 26, 2010, 02:21:19 pm

Approximately 6 weeks ago, Grampa did some patterns for me of my kids dogs. With his help, my skills are increasing. I would publicly like to say "Thank you Paul".

I have attached the finished project. For me being a newbie with a scroll saw, they came out fine. I am very please with them.

Please also note: A few weeks ago, I posted a question about making frames. Via your suggestions, two weeks ago I purchased a Kreg 3 Master System. One of the best, non-power, tools I have purchased. The frames in the pictures below where joined together using this tool.

Title: Re: Thanks Grampa for your Help
Post by: julief on October 26, 2010, 02:23:52 pm

Excellent, Sam.

Title: Re: Thanks Grampa for your Help
Post by: MadHatter on October 26, 2010, 02:29:25 pm

wonderful job!!

Title: Re: Thanks Grampa for your Help
Post by: Dawie on October 26, 2010, 02:53:15 pm

They look great Sam. Thanks for sharing.
David

Title: Re: Thanks Grampa for your Help
Post by: GrayBeard on October 26, 2010, 02:56:21 pm

Very, Very Nice!

Great work on both the portraits and the frames.

And MY Thanks also to Paul for all he does!

~~~GrayBeard~~~

Title: Re: Thanks Grampa for your Help
Post by: Russ C on October 26, 2010, 03:59:13 pm

You have been busy. They look great, nice work.  8)

Title: Re: Thanks Grampa for your Help
Post by: boxmaker on October 26, 2010, 09:49:51 pm

Wow good job Sam. And my thanks to Grampa for doing the patterns, we are very fortunate.

                                                    Mark

Title: Re: Thanks Grampa for your Help
Post by: Judy Hunter on October 27, 2010, 12:38:32 am

Those are really great!! Both the pattern and the cutting.

Title: Re: Thanks Grampa for your Help
Post by: newfie on October 27, 2010, 08:00:24 am

wow great work here sam