Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: KarlB on October 23, 2010, 05:01:27 pm

Title: Filet and Release -- A Steve Good pattern
Post by: KarlB on October 23, 2010, 05:01:27 pm

When Steve posted this pattern the other day, I knew I had to make it for a friend.  Then my wife suggested a family member.  So I have two for now:

1st one:  Pattern:  Steve Good
              Wood:     Alder  1" thick
              Finish:     None yet.

2cd one:  Pattern:  Steve Good
              Wood:     Pine
              Finish:     None yet.

My only problem with the pattern is the word: Filet.  I looked it up and it is correct, but I've always used fillet (with two L's).  (By the way the spell checker here doesn't recognize it.)

So I question each viewer, should it be "filet" or "fillet"?  What do you normally use?

Karl

Title: Re: Filet and Release -- A Steve Good pattern
Post by: Dawie on October 23, 2010, 05:25:04 pm

They turned out great. How are you going to finish them?
David

Title: Re: Filet and Release -- A Steve Good pattern
Post by: dgman on October 23, 2010, 05:45:23 pm

Hey Karl, My spell checker (my wife) says it is spelled with one L.
Nice cuttings by the way!
P.S. IE spell checker says it is spelled with two Ls!

Title: Re: Filet and Release -- A Steve Good pattern
Post by: MadHatter on October 23, 2010, 06:47:06 pm

nice work, thanks for sharing with us. and i think its spelled with one L.     :)

Title: Re: Filet and Release -- A Steve Good pattern
Post by: Russ C on October 23, 2010, 07:04:29 pm

Nice job, I like them. Thanks for posting your work. Have you decided on a finish?  8)

Title: Re: Filet and Release -- A Steve Good pattern
Post by: KarlB on October 23, 2010, 09:17:11 pm

Thanks for the comments.

As for the finish I don't know.  I like the look of Alder and will probably use a spray lacquer.  Pine looks nice, but it already has too many fuzzies on it so any water stain is out.  (The Alder had very little fuzzies and what was there was easily removed with my flutter wheel.)  I may use Golden Oak on it with a spray lacquer on top.

Other ideas?

Karl

Title: Re: Filet and Release -- A Steve Good pattern
Post by: dunk on October 24, 2010, 11:35:34 am

If you Google the spelling of Filet.  if it has to do with fish it is Filet.  Fillet is a welding term.

Quote

fillet... or filet... how do you spell it? - www.ifish.net
18 posts - 15 authors - Last post: May 8, 2008
You are looking for the "filet" spelling if you are going to use it in a fishing context. "Fillet" is a type of weld. ...
www.ifish.net ? ... ? Ifish Community

However you decide, your 2 examples look very nice.

Title: Re: Filet and Release -- A Steve Good pattern
Post by: newfie on October 25, 2010, 10:12:48 am

nice work Karl.