Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: scrollriffic on October 06, 2010, 06:59:32 pm

Title: Relief Nativity
Post by: scrollriffic on October 06, 2010, 06:59:32 pm

Here is a nativity I cut out of oak using a relief cut. 5 degree angle with #7 blade.Bobby

Title: Re: Relief Nativity
Post by: GrayBeard on October 06, 2010, 07:00:27 pm

Bobby...you forgot to attach the photo!

~~~GB~~~

Title: Re: Relief Nativity
Post by: scrollriffic on October 06, 2010, 07:01:32 pm

Is That better

Title: Re: Relief Nativity
Post by: GrayBeard on October 06, 2010, 07:25:48 pm

Very Nice! And a photo too!

Good Job!

~~~GB~~~

Title: Re: Relief Nativity
Post by: boxmaker on October 06, 2010, 08:44:55 pm

Nice one Bobby, I have never tilted my table yet, I'll have to try it.

                                                                         Mark

Title: Re: Relief Nativity
Post by: MadHatter on October 06, 2010, 09:42:33 pm

very nice job. ill have to try that one too. thanks for sharing with us.

Title: Re: Relief Nativity
Post by: Marcellarius on October 07, 2010, 12:43:54 pm

looks great. I like the 2 different type of wood

Title: Re: Relief Nativity
Post by: dunk on October 07, 2010, 01:36:45 pm

Nicely done!

Title: Re: Relief Nativity
Post by: Dan on October 10, 2010, 10:27:12 am

Super work. Thanks for sharing.

Dan

Title: Re: Relief Nativity
Post by: Dawie on October 14, 2010, 03:03:58 am

Looks great.
David

Title: Re: Relief Nativity
Post by: Merlin on October 14, 2010, 06:49:38 am

Nice one Bobby, is the pattern available.

***Merlin***

Title: Re: Relief Nativity
Post by: sp_343 on October 14, 2010, 08:07:01 am

Turned out great!  Thanks for sharing the picture...

Title: Re: Relief Nativity
Post by: newfie on October 19, 2010, 08:02:40 am

wow thats nice Bobby thanks for posting.