Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Danny on August 04, 2010, 07:37:35 pm

Title: I need a pattern of especially a rose, but any flower wud be great....:+}
Post by: Danny on August 04, 2010, 07:37:35 pm

Hey guys....I am using Steve's pattern of a butterfly on his blog.  Have sized two butterflies to fit on the only half inch wood I can buy (oak) and the length will be 12 inches.  I really like the way I have them spaced, but I think a few flowers would look really good.  Mostly the top of a flower.  I want to cut all out where they will be a quarter inch above the wood depth.  And like Steve's pattern with a backer and spacer for the butterfly patterns and roses.
Anyway I hope you all understand all the giberish.  Thanks in Advance
                                                                          Dusty Dan  :+}

Title: Re: I need a pattern of especially a rose, but any flower wud be great....:+}
Post by: grampa on August 04, 2010, 07:50:24 pm

Hi Dan, this is the only Flower that I have......Paul ;D

Title: Re: I need a pattern of especially a rose, but any flower wud be great....:+}
Post by: bill g on August 14, 2010, 03:10:38 pm

ill try to post this for you if i can get the attachment to work

Title: Re: I need a pattern of especially a rose, but any flower wud be great....:+}
Post by: bill g on August 14, 2010, 03:13:55 pm

found another

Title: Re: I need a pattern of especially a rose, but any flower wud be great....:+}
Post by: Danny on August 15, 2010, 10:17:14 am

Thank You Bill....  Now your design of a rose is simply Beautiful.  I shall be cuttin it real soon.  Thanks again....  Danny  :+}