Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: budprine on August 01, 2010, 01:14:45 pm
-
I recently acquired a 12 1/2" surface planer to use in a re-sawing process. I also came into some badly weathered lumber that needed to be cleaned up. After doing some planing I noticed it was easier to sweep up the shavings rather than try to suck them up with a shop vac. My wife saw what I had collected and said "why don't you put that on the flower beds"
That got me thinking about how much stuff I throw away from the shop vac. Why can't it also go to the flower beds instead of to a land fill?
Certainly I'll have to magnetically remove the occasional screw or nail that might find its way into the shop vac.
Who else collects and recycles their debris. Are there any negatives to doing this?
-
I have always dumped my sawdust and shavings into my garden beds except for the exotic woods. Some of these will cause problems and work against your flowers or veggies. I always say "What comes out of the ground should go back into the Ground" but of course as with every thing else there are exceptions. If your not sure of certain matter being recycled into your garden then do some research on the matter.
Mike
-
I agree some wood shavings can be or are toxic to your plants.
-
Oh come on now.. All my shavings go into my flower beds for years now. "toxic to your plants" by the time mother nature breaks it down it is not toxic. It is just wood people. ::) ::) ::) Or unless You are dumb enough to use pressure treated lumber. ::) ::) ::)
-
Just don't build up mulch beds too deep or wide around a foundation. It is possible for subterranean termites to use the mulch to avoid treated areas of soil and find a way into your house (not likely, but possible).
-
Do Not put walnut chips in a flower bed, or garden! The acid in walnut chip will kill just about anything. But pine, or oak chips are fine. Just my .02 worth.
Oz
-
I think you need to read my post again.,,,I said "Or unless You are dumb enough to use pressure treated lumber." Pressure Treated Lumber not black walnut shavings. I really don't know how you got it confused. So for the record I did not call you dumb, dunk. Pressure Treated Lumber should never be used for mulch or not even burned, the smoke is poisonous. Most pressure-treated lumber sold before January 2004 was treated with chromated copper arsenate (CCA for short), which contains arsenic. http://www.co.thurston.wa.us/health/ehhm/cca.html (http://www.co.thurston.wa.us/health/ehhm/cca.html). It just won't kill plants, it kills humans and animals. So I think anyone would be dumb to make mulch/shavings from Pressure Treated Lumber.
-
Well Russ, I must agree with Dunk.
Not only walnut but, there are alot of woods that are not good for gardens or ground cover.
This subject came up on another wood working fourm and the general thought was, "Trash it or burn it but, it wont help to retain the moisture to help the garden and it can harm alot of plants."
You are right about "Treated wood, "Don't even burn it!".
There have been cases where walnut and others have been used for bedding for horses and other animals and they have died from it.
My wife buys cider chips to put around the trees and in her flower garden and it does help to keep the weeds down but, I dont see any reason to toss it on a garden or flower plot.
Rog