Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: hurrysundown2 on June 23, 2018, 09:12:49 pm

Title: Glue type for project
Post by: hurrysundown2 on June 23, 2018, 09:12:49 pm

Hello I made a few of the Inlay oval keychains now not sure what type of glue to use.Putting them in oven.has me wondering what is best.If anyone had any problems with glue ups.Thanks again.   Tom

Title: Re: Glue type for project
Post by: don in brooklin on on June 24, 2018, 07:58:30 am

I just used regular Titebond III.

I cut the name in maple and they glued that piece to another piece of maple.  Then cut the oval that way you don't have to worry about mistakes between the top and bottom. 

I can't remember any issued with the glue when heating of the clay.

Only did a few and no one complained afterwards. 

These were made some 6 years ago and I know that one is still on her backpack.

Title: Re: Glue type for project
Post by: hurrysundown2 on June 24, 2018, 07:58:06 pm

Thanks Don yours looks great.Ill start with the titebound 3.Ill post how they turned out making a few when I get some free time.