Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: dgman on July 24, 2010, 08:04:40 pm

Title: Murphy
Post by: dgman on July 24, 2010, 08:04:40 pm

Saw the pattern this morning on Steve's blog. Started at 10:00 am by milling the oak board to 1/2", Sanding to 220 grit then started cutting. Cut 3/4" Mahogany to size then routed the edge. Glued together and drying by 1:00 pm. Soaked in linseed oil and mineral spirits mix. Pic taken just a few minutes ago.

Title: Re: Murphy
Post by: cyclistjim on July 24, 2010, 08:15:56 pm

It came out nice! :)

Title: Re: Murphy
Post by: northie66 on July 24, 2010, 08:41:01 pm

It looks nice.  Anyone know what the font name is on this?

Title: Re: Murphy
Post by: dgman on July 24, 2010, 08:47:06 pm

Judy says its Black Rose from Dafont.com

Title: Re: Murphy
Post by: northie66 on July 24, 2010, 08:49:34 pm

Thanks dgman... nice font.

Title: Re: Murphy
Post by: sp_343 on July 24, 2010, 09:39:50 pm

Another nice piece!  Can't wait to try the Linseed oil/Min Spirits mix on my next project.  Thanks for the pic!

Title: Re: Murphy
Post by: MadHatter on July 24, 2010, 10:40:21 pm

very nice, thanks for sharing.

Title: Re: Murphy
Post by: BilltheDiver on July 24, 2010, 11:19:28 pm

Gotta say thanks to Steve for this one.  My last name is Murphy.

Title: Re: Murphy
Post by: Dawie on July 24, 2010, 11:44:32 pm

Nice piece once again dgman.
David.

Title: Re: Murphy
Post by: Russ C on July 25, 2010, 12:24:36 am

Nice job, I like it. Thanks for posting your work.  8)

Title: Re: Murphy
Post by: Becky on July 25, 2010, 12:38:13 am

Mo moss growing on you, dgman!  Nice job.