Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: Jim-78028 on January 05, 2016, 07:05:01 am
-
Ok the first couple of what will be many newbie questions. :)
1. Wandering around the net I see some recommending that the table top that the wood rests on be waxed. What is the consensus? and if so what wax?
2. When the saw is not being used, should the blade tension be relaxed or does it matter?
TIA
Jim
-
Jim; I will wax my scroll saw once in awhile when the weather is good, saves on rust and cleans it up. I also do it to my table saw and the table on my drill press. But what works in a pinch is grab a piece of wax paper out of the kitchen(or the whole roll if your wife is not looking) rub it on your table top and it works great. When done scrolling for even a little while I will take the blade clear out of the machine. Delta says to take the tension off but I just remove it completely, in hopes of saving the tension system
Bill
-
I use Johnson's Paste Wax and it works great. I have never made any worry about the tension as it usually stays where it was when I quit. Have used my Q3 since 94 and no problems.
-
I too use Johnson's Paste Wax as it contains no silicone. Silicone can leach into your wood and ruin a project.
I've been scrolling since the mid 80's and I always release the tension on my blade on my SS and my band saw. Just seems to me it will reduce stress on the mechanical parts (and the wheels on the band saw) and the blades themselves.
-
Johnson's Paste wax on all my tools.
-
Dryer sheets made to eliminate static in your clothes dryer work well for waxing
the table with no residue also.
God Bless! Spirithorse
-
I use a paste wax intended for wood, such as Johnson's or Minwax. I would not use a paste wax intended for cars, because of the concerns over silicone contamination. I only have to wax a few times a year and it only takes a couple minutes. A can of wax will last for years. It just makes moving the wood around on the saw so much easier. Eventually, with use, the table's surface does get rough enough to impede the movement of the wood. I do the same with my planer, table saw, router table and bandsaw tables. I've not tried the wax paper or dryer sheet ideas. They sound interesting.
I try to remember to de-tension the blade when the saw is not in use. I do the same with my bandsaw. I just think it's good practice and certainly doesn't hurt anything.
-
I use Johnson's paste wax on all my tools. TS, planer, especially my scroll saws. With experience, you'll find cast aluminum decks have a tendency to need a little more attention compared to cast iron. One trick I have learned to use on my cast aluminum decks, use 0000 steel wool lightly over the deck before waxing. Basically all this does is help clean the junk off, & polish the deck a little before you put wax on.