Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: no1texan on December 11, 2015, 05:12:11 am

Title: Cutting out the 2015 Layer Christmas Ornament - Center layer - Snowman
Post by: no1texan on December 11, 2015, 05:12:11 am

In cutting out the snow man?s mouth, do you drill a hole for each hole and use the blade to finish the shape? This seems to work ok on the middle three holes. The two outside holes I have just drilled the hole and left it as is.

Title: Re: Cutting out the 2015 Layer Christmas Ornament - Center layer - Snowman
Post by: don in brooklin on on December 11, 2015, 06:50:51 am

I did the same.

Title: Re: Cutting out the 2015 Layer Christmas Ornament - Center layer - Snowman
Post by: dunk on December 11, 2015, 10:26:00 am

Me too. 

Title: Re: Cutting out the 2015 Layer Christmas Ornament - Center layer - Snowman
Post by: KarlB on December 11, 2015, 05:22:44 pm

no1texan you shouldn't post these patterns as these are the ones that Steve charges for.

You may not be aware of this.

Karl