Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: MOONIE on September 26, 2015, 09:45:02 am

Title: Need Help. 'Stencil'
Post by: MOONIE on September 26, 2015, 09:45:02 am

What suggestions do ya'll have for a stencil pattern?  I need to make word art gifts for a friend.  It must be free. There are many on line, but I'm afraid of importing a Trojan or malware and the like.   Thanks for your help.

Title: Re: Need Help. 'Stencil'
Post by: daveo on September 26, 2015, 10:36:09 am

hi

yes that always bothers me too, if you use the link below you wont get any problems, or a least i never have
Dave

http://www.1001fonts.com/free-fonts-for-commercial-use.html?page=31&items=10

Title: Re: Need Help. 'Stencil'
Post by: MOONIE on September 28, 2015, 08:50:56 pm

Thank you, but,   not what I'm looking for.   It runs in my memory, Steve had a pattern maker that would have a base on the bottom. Something like his key fob pattern maker.  Moonie

Title: Re: Need Help. 'Stencil'
Post by: Rapid Roger on September 29, 2015, 10:46:19 am

If you go to Steve's home site and search for "Stencil Maker", I'm sure that is still in there some place. I tried a quick look and couldn't find it right away but, I didn't do a search either.  ;)
I've used it quite a bit and it takes some learning right at first but, once you figure it out, it works great!
Just keep looking, it has been a few years since he made it.  ::)

Rog

Title: Re: Need Help. 'Stencil'
Post by: MOONIE on September 29, 2015, 09:47:00 pm

Thank you,   I did a search without finding what I was looking for.   Moonie