Scrollsaw Workshop Community -Please register to enable posting.

General Category => Intarsia => Topic started by: Claymore on May 17, 2015, 02:30:17 pm

Title: Flying Duck Intarsia
Post by: Claymore on May 17, 2015, 02:30:17 pm

Hi,
Just finished my latest Intarsia project (still has to be lacquered but easier to photograph before doing so)
As you can see its a Flying Duck approx size 22" x 20" x 3/4"  woods used Oak/Walnut/Silver Birch and Beech with a Teak Frame  as usual all woods from knackered charity shop furniture (the stuff they normally smash up and stick in the skips)  as i use mainly small pieces its a great source for cheap hardwood's and they still make some money from me buying them so everyone's happy.
I am slowly speeding up certain stages with my Intarsias and using stuff like the Sand-Flee Polishing mop saves loads of time and gives a lovely finish (it also polishes your fingers which tend to sting a bit lol)
Hope you like it
Cheers
Brian

Title: Re: Flying Duck Intarsia
Post by: spirithorse on May 17, 2015, 11:55:52 pm

Nice work, Brian,
Thanks for sharing and God Bless! Spirithorse

Title: Re: Flying Duck Intarsia
Post by: heiko rettberg on May 18, 2015, 01:30:30 am

Looks greate, good Job.

Title: Re: Flying Duck Intarsia
Post by: Claymore on May 18, 2015, 03:43:09 pm

Thanks everyone  :)  It was a nice one to do and although not many pieces i think the chunky effect works well and has given me a few more ideas for my own patterns.
Cheers
Brian

Title: Re: Flying Duck Intarsia
Post by: Rover2 on May 18, 2015, 08:20:04 pm

Great job Brian.  Thanks for sharing.

Al

Title: Re: Flying Duck Intarsia
Post by: wombatie on May 19, 2015, 03:03:31 am

The love the fact that its not just a duck on its own, its an actual picture.  I love it.  Well done.

Marg

Title: Re: Flying Duck Intarsia
Post by: Claymore on May 19, 2015, 01:55:14 pm

Thanks Marg 8-)
Brian