Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: rdatelle on January 01, 2015, 08:02:18 pm

Title: Hoping for a pattern.
Post by: rdatelle on January 01, 2015, 08:02:18 pm

This is my Great Granddaughter and I was wondering if one of you great pattern makers can do this for me. I'm not sure if it's to close to do. Would make a nice portrait though. Thanks guys.

Title: Re: Hoping for a pattern.
Post by: daveo on January 02, 2015, 11:40:44 am

Ralph here is one attempt

Dave

Title: Re: Hoping for a pattern.
Post by: pierre62 on January 02, 2015, 12:24:21 pm

Very nice pattern  rdatelle must be very happy.
Have a good day!

Title: Re: Hoping for a pattern.
Post by: mikachantournage on January 03, 2015, 09:24:43 am

Hello , this is what I realized thank you to you to tell me that you will

  Mikachantournage

Title: Re: Hoping for a pattern.
Post by: rdatelle on January 03, 2015, 11:25:14 am

Thanks guys. They both look good. The hair looks like it could be a challenge. Well I'll see how I do. I'll post one of the finished one;s here when I'm done. Thanks again. I knew you would come through with a pattern for me.

Title: Re: Hoping for a pattern.
Post by: rdatelle on January 03, 2015, 11:37:28 am

Well after printing out the patterns I think I will do Daveo. It looks like the hair will be a little easier to do. Tough decision.

Title: Re: Hoping for a pattern.
Post by: rdatelle on January 04, 2015, 04:28:19 pm

Well here's my try at the pattern Daveo made for me. It didn't come out to bad. Hope she likes it. Thanks again Daveo.

Title: Re: Hoping for a pattern.
Post by: EIEIO on January 04, 2015, 05:44:41 pm

Nice job. The hair is always the hardest part for me.

Title: Re: Hoping for a pattern.
Post by: Rover2 on January 04, 2015, 07:59:24 pm

Nice patterns and nice cutting.  Great job and thanks for sharing.

Al

Title: Re: Hoping for a pattern.
Post by: wombatie on January 06, 2015, 12:21:32 am

The patterns are great guys.  You did a really good job with cutting it, gotta be happy with that.

Marg