Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: DWSudekum on December 29, 2014, 09:26:41 pm
-
This is what I use for my blade storage. The pull out drawer sits to the left of my saw. I had a set of drawer slides from a cabinet that reclaimed.
(http://s6.postimg.org/eqjhxwmr1/Blade_Storage_and_DW788_Dust_Colllection_001.jpg) (http://postimg.org/image/eqjhxwmr1/)
(http://s6.postimg.org/u0jd53i99/Blade_Storage_and_DW788_Dust_Colllection_002.jpg) (http://postimg.org/image/u0jd53i99/)
For the dust collection I made a simple 8 inch in diameter bowl, cut it in half. Since I had the stand that provided a good base to mount a board with a hole in it for the suction. I glued one of the halves of the bowl to that board. For the suction I was able to find a defective 1 hp harbor freight dust collector. I replaced the motor with an old motor I scavenged someplace a couple of years ago. While it does not get every bit of dust it does for the most part keep it off the floor. It i s not too noisy either.
(http://s6.postimg.org/yc7yu3p65/Blade_Storage_and_DW788_Dust_Colllection_003.jpg) (http://postimg.org/image/yc7yu3p65/)
(http://s6.postimg.org/smrq9sizx/Blade_Storage_and_DW788_Dust_Colllection_005.jpg) (http://postimg.org/image/smrq9sizx/)
(http://s6.postimg.org/dtd2p1b8t/Blade_Storage_and_DW788_Dust_Colllection_006.jpg) (http://postimg.org/image/dtd2p1b8t/)
DW