Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: rdatelle on November 09, 2014, 05:20:57 pm

Title: Potrait finished
Post by: rdatelle on November 09, 2014, 05:20:57 pm

This is one of the portraits I finished for my niece. This is a pattern that Mahendra did for me.

Title: Re: Potrait finished
Post by: DWSudekum on November 09, 2014, 06:20:43 pm

Nicely done Ralph.  Thanks for sharing this with us.

DW

Title: Re: Potrait finished
Post by: frankorona on November 10, 2014, 06:55:50 am

Great job, it looks wonderful, thanks for sharing.

Title: Re: Potrait finished
Post by: pddesertrat on November 10, 2014, 09:27:38 am

Well done.  What thickness of wood are you using.

Title: Re: Potrait finished
Post by: countryscroller on November 10, 2014, 09:58:49 am

Great work! Thanks for sharing.

Title: Re: Potrait finished
Post by: pierre62 on November 10, 2014, 10:29:28 am

Well done.
Thanks for sharing.

Title: Re: Potrait finished
Post by: rdatelle on November 10, 2014, 01:15:41 pm

I usually use 1/4 birch but I did this one in 1/8 birch and doubled it up so I got two of them done. I'll give one to my niece and one to her mother.

Title: Re: Potrait finished
Post by: gordster on November 10, 2014, 05:14:20 pm

Good work Ralph, nice cutting, well framed