Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: gordster on September 04, 2014, 11:11:35 pm

Title: 3D
Post by: gordster on September 04, 2014, 11:11:35 pm

One of Steves 3d ornaments

Title: Re: 3D
Post by: wildhorse on September 05, 2014, 01:53:11 am

Nicely done.

Title: Re: 3D
Post by: spirithorse on September 05, 2014, 02:27:19 am

Nice work!
Thank you for sharing and God Bless! Spirithorse

Title: Re: 3D
Post by: wombatie on September 05, 2014, 04:56:37 am

Very nice.

Marg

Title: Re: 3D
Post by: DWSudekum on September 05, 2014, 06:11:50 am

Very nicely done.  Thanks for sharing this with us.

DW

Title: Re: 3D
Post by: pierre62 on September 05, 2014, 06:37:32 am

Very nice !

Title: Re: 3D
Post by: frankorona on September 05, 2014, 08:15:21 am

Wonderful ornament, thanks for sharing.

Title: Re: 3D
Post by: pddesertrat on September 05, 2014, 10:20:09 am

Nice!

Title: Re: 3D
Post by: EIEIO on September 05, 2014, 10:32:16 am

That's a nice looking piece. What wood did you use for the compound cut?

Title: Re: 3D
Post by: gordster on September 05, 2014, 03:46:07 pm

I used a piece of basswood I  have.The 1st one came out good, but second one I broke.Since then I have read a tip .not go complete full cut as to keep pieces together for strength.then cut off lsst holding spots.then wiggle it apart, dust stays in to make it more fun lol.

Title: Re: 3D
Post by: newfie on September 12, 2014, 09:37:17 pm

great work thanks for sharing

Title: Re: 3D
Post by: Marcellarius on September 13, 2014, 06:22:23 am

very nice cutting. looks great

Title: Re: 3D
Post by: countryscroller on September 17, 2014, 07:40:55 am

Great work! Thanks for sharing.

Title: Re: 3D
Post by: Bullfighter on September 22, 2014, 03:04:57 am

So beautiful, nice job. My wife loved it.

Title: Re: 3D
Post by: Rover2 on September 22, 2014, 09:15:30 pm

I was playing around one day and made that ornament out of the only thing I had on hand at the time which was Pine and managed to break it only seconds after cutting.  Next time I will use a better wood.
Yours came out great.  VERY nice work and thanks for sharing with us.
Al