Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: srollRoger on August 28, 2014, 02:14:11 pm

Title: Triumph 75
Post by: srollRoger on August 28, 2014, 02:14:11 pm

Thanks Daveo. wonderful pattern.
Greting from Roger.

Title: Re: Triumph 75
Post by: pddesertrat on August 28, 2014, 03:02:58 pm

You certainly did it proud!  Nice scrolling.

Title: Re: Triumph 75
Post by: Tomsunnu on August 28, 2014, 09:50:09 pm

Roger, good job!

Title: Re: Triumph 75
Post by: gordster on August 29, 2014, 05:48:44 am

Fantastic cutting Roger

Title: Re: Triumph 75
Post by: pierre62 on August 29, 2014, 06:28:37 am

Great work Roger

Title: Re: Triumph 75
Post by: frankorona on August 29, 2014, 07:44:54 am

Very nice work, thanks for sharing.

Title: Re: Triumph 75
Post by: Ray on August 29, 2014, 09:02:36 am

Excellent work!

Ray

Title: Re: Triumph 75
Post by: daveo on August 29, 2014, 11:38:35 am

Hi Roger
An excellent cut, and thanks for the thanks
however when I took a close look at the cut, somrething did not seem right, so I have just run a trace on the cut and set it at the side of the original patter, and there are quite a few distinct differences, but I cant work out how you did it ???
what did you do, a complete re run or some other form of trickery, just curious :) :) :)

Dave