Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: Jim Finn on April 10, 2014, 11:17:47 am

Title: Cross/fish compound cut.
Post by: Jim Finn on April 10, 2014, 11:17:47 am

3" tall made of Mahogany.  Made in less than 1/2 hour including spray finish.

Title: Re: Cross/fish compound cut.
Post by: DWSudekum on April 10, 2014, 12:24:55 pm

That came out great Jim.  Compound cutting can be loads of fun.  Thanks for sharing this with us.


DW

Title: Re: Cross/fish compound cut.
Post by: Rover2 on April 10, 2014, 08:31:33 pm

very nice Jim.  How thick is it and what kind of blade did you use?   Looks really good and thanks for sharing.

Title: Re: Cross/fish compound cut.
Post by: Jim Finn on April 10, 2014, 10:10:17 pm

I cut this from a piece of mahogany 1 3/4" x 1 1/2" x 3" using a flying Dutchman polar #5 blade.  Made the pattern my self.  I got the idea from a similar piece here in Lubbock that looks to be nine feet tall made of medal.

Title: Re: Cross/fish compound cut.
Post by: wombatie on April 11, 2014, 04:26:17 am

Very interesting.   Great work Jim.

Marg

Title: Re: Cross/fish compound cut.
Post by: frankorona on April 11, 2014, 07:58:17 am

Excellent work, both look great, thanks for sharing.

Title: Re: Cross/fish compound cut.
Post by: newfie on April 11, 2014, 10:57:43 pm

I cut a couple of them.I like cutting those 2 sided compound  ones. Thanks for sharing

Title: Re: Cross/fish compound cut.
Post by: Marcellarius on April 12, 2014, 08:22:00 am

great idea, great cutting, great job.