Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: scrollsaw22 on December 16, 2013, 11:38:09 pm
-
Been a while since on the site. Thought would share this iPhone Passive Speaker. Looked around the net and found different ways these have been made and made up my own pattern. Used Forstner bits to do the holes progressively smaller and deeper. Made of 3 pieces of wood, 2 pieces 3/4" Walnut and 1 piece not sure of the specific wood, some type of exotic that I had purchased a while back. Middle piece of walnut has the groove in it for the sound to travel out to the holes. Brass screws in the corners are more decoration now than when assembling. Added the "H" (1/16" Slolid Brass) and .040 Copper to it for decoration and stability on the bottom. Going to give as present at work for secret Santa gift.
-
Interesting... wonder how well it works? Looks great though. Thanks for sharing this with us.
DW
-
DW...works amazingly well, would say it increses volume by at least 50% or better. Tested another iphone on it before I put the finish on.
-
Nice looking work. Thanks for letting us have a peek.
Al
-
Wonderful job, looks great, thanks for sharing. ;)