Scrollsaw Workshop Community -Please register to enable posting.
General Category => General Scroll Saw Talk => Topic started by: gilljc on December 02, 2013, 03:13:20 pm
-
I have just finished cutting my first portrait style picture of a dressage horse and rider, and rather than putting it in a frame behind glass, I want to mount it onto a backer board, I have routed the edges of the backer, and painted it black with a satin finish, and am wondering what would be the best glue to give the best and most secure bond?
I have masked some areas where I could, but am worried about it not bonding thoroughly onto the paint.
this is to be a gift, and I would hate for it to fall apart - any advice gratefully received :)
-
For starters, you need to be sure and have a good wood to wood contact in at least several spots. Example... each corner and at least one place along each edge and one or two near the center. Then you can use good old yeller wood glue like Elmers or Titebond. If you try to glue anyplace with a finish on it, the glue won't hold for very long and in fact may cause the finish to separate from the wood.
I use Titebond glue for everything I do and it is the strongest I can find. With a good wood to wood surface to glue to, the wood will break before the glue will let go.
Hope that helps.
Rog
-
Aleene's original tacky glue will adhere painted surfaces. It is available at Michael's and other craft stores. Water clean up.
-
To add to Dougturner's response, I used Aleen's Clear Gel Tacky glue a lot. It starts out clear and dries clear. I know you shouldn't have squeeze out, but if you do, it is hidden by the clear glue. Turbo glue by Aleen's dries clear also, just comes out white instead of clear. I buy mine at Walmart in the craft section.
-
This stuff seems to glue anything to anything. Wallmart, Michaels etc...
Pete
-
Aleene's tacky glue. You will have squeeze out. I try to clean up the squeeze out with a toothpick, but some areas are just too tight. It will dry clear so it wont be a problem. E-6000 is a great glue to have on hand, but is thick and I wouldn't use it for portrait work. I use it on a lot of other things. Both glues will adhere to painted surfaces. I brush on the aleenes with a glue brush on the back side of my portrait, making sure to get all of the outer edges. Then weight it down for a while. Aleenes dries pretty quickly and does a great job.
-
Aleen's on painted - finished surfaces and paper/ ood glue on wood to wood and super glue on other things
-
I use Titebond 3 and never had any problems with it, make sure it is clamped down well. Also weldbond works great also, and dries clear. edward
-
This was a great question. I have been facing the same problem. Thanks for all your help, I will try Aleen's tacky glue and also E-6000.