Scrollsaw Workshop Community -Please register to enable posting.
General Category => Tutorials, Techniques and Tips => Topic started by: Rapid Roger on October 30, 2013, 06:51:51 pm
-
Going to try to load a tute on how I made a segmented vase. I hope it works. ;)
This is NOT necessarily the right way to do it, it is just my way. I have another idea to try and see if it can be done any easier.
This is a picture tute and not really a lot of description so if you have questions feel free to ask and I'll try to give you an answer.
http://s193.photobucket.com/user/rapidroger/library/Segmented%20Vase%20Construction
Does this work?
Rog
-
Great sequence of photos.
Photobucket always seems to misbehave when I go to it, but that's not your problem.
-
Very nice project! I looked through the other tabs and you have some amazing work on there! Great job.
-
Roger , thanks for the visuals and I second Dustin on all your projects. Is the thickness is 1/2 inch of the mixed blank you made?
Mahendra
-
Tomsunnu,
The wood used was 3/4" thick. I bought rough cut wood and used my planer to make all of the pieces smooth and the same thickness to start out with. Then cut the pieces to 7-1/2" square before laying out the pattern. The vase ended up being about 7-1/4" diameter at the center and 10" tall overall.
By the way, I don't mind you guys looking a all my old projects but, to be honest, I didn't mean to send my whole "Photobucket"! I just meant to send the one album of the tutorial.
Sorry, I'm just not computer savy when it comes to things like that. :P ::) :-[
Rog
-
Roger,
Thanks :) Tech savy or not, it was feast to the eyes to see your work.
Mahendra