Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: skip on October 28, 2013, 11:37:31 am

Title: name plate
Post by: skip on October 28, 2013, 11:37:31 am

would like to see if i could get a pattern   a name plate       ROBBIES PLACE   would like the first letter R to be about 2 inces high   going up to the s about 3 inches than back down to 2 inches for the e on place   how i made that sound right   thank you very much     skip

Title: Re: name plate
Post by: Proxprof on October 28, 2013, 05:19:23 pm

Hello Skip,

I gave it a try.
Is this what you mean?
You have to print it in the right size.
I'm new to this so give me some respons.

Richard

Title: Re: name plate
Post by: skip on October 28, 2013, 05:50:32 pm

how about a space  between robbies and place  other than that agood job  thank you

Title: Re: name plate
Post by: Russ C on October 28, 2013, 07:14:26 pm

Name plate? Do you mean as in, sits on a desk or hangs on a wall?

Title: Re: name plate
Post by: skip on October 28, 2013, 07:48:40 pm

one for the desk would be fine     thank you

Title: Re: name plate
Post by: Russ C on October 28, 2013, 09:28:02 pm

How about this.

Title: Re: name plate
Post by: skip on October 29, 2013, 06:47:34 am

good one russ  thank you very much

Title: Re: name plate
Post by: frankorona on October 29, 2013, 08:33:55 am

Very nice patterns, thank you for your help

Title: Re: name plate
Post by: kingcole on November 12, 2013, 09:28:06 am

go to steve d goods blog  he has several free programs that you need to help you make your own patterns

Title: Re: name plate
Post by: EIEIO on November 12, 2013, 11:25:21 am

Just to make sure - You might want to check the syntax before cutting.

If the name is "Robby" then the sign should probably read "Robby's Place" (also note the apostrophe).

If his (or her) name is "Robbie" then it should look like "Robbie's Place" (adding the apostrophe).

If it's already a trademark w/o the apostrophe then leave it off.

Title: Re: name plate
Post by: skip on November 12, 2013, 05:01:06 pm

he liked the one russ drew  so we cut that one     i glad i didnt have to choose  they were are  good   i put a picture of it on here   i think in the brag section    THANK YOU ALL    SKIP