Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: gertie birdie on October 27, 2013, 01:33:32 pm

Title: Coin Cutting Jig
Post by: gertie birdie on October 27, 2013, 01:33:32 pm

Hello.. I'm new to the Scroll Saw. I'm going to be using it mostly for jewelry making. I was truly hoping to purchase the Coin Cutting jig from Steve. I don't have the skills to make it myself. Would it be possible to purchase this item? Thank you.

Title: Re: Coin Cutting Jig
Post by: dunk on October 28, 2013, 12:31:38 pm

Check your e-mail...If Steve is to busy I'll be glad to help you out.  You van just use a craft stick and hot glue your coin to that and release it with a hair dryer when you are through cutting as well.