Scrollsaw Workshop Community -Please register to enable posting.
General Category => Pattern Requests. => Topic started by: willieg on September 07, 2013, 08:52:54 pm
-
I would like a pattern of JACK,if one of you guys could give it a go. I am trying to learn to convert a photo to some thing that looks like a pattern but have not yet been to sucessful,all of you PATTERN MAKERS are so good I should just spend my time sawing them...
-
I think it you photographed him against a light background it would help and perhaps a side or angling shot would make it easier for the guys who do this sort of thing. Maybe some of them will chime in here and tell you what's needed. Good luck,
I've got a soft spot for Shepherds!
Gabby
-
Willie - I took a shot but this is a very small image and it's difficult to get much detail into the pattern. I'll try again later, but for now I'm stalled at the image below, which I'm not happy with.
-
Willie - I took a shot but this is a very small image and it's difficult to get much detail into the pattern. I'll try again later, but for now I'm stalled at the image below, which I'm not happy with.
That is a tough one Ray, the detail is very confused!
Gabby
-
Your right Ray, the size and background was tough, but I gave Jack a shot.
-
Nice one Ron
-
Your right Ray, the size and background was tough, but I gave Jack a shot.
[/Thanks for the effort I snagged a copy,looks pretty good to mequote]
-
Here's a render of Jack from a different photo.
-
Good job Ron! Now it's up to Willie to use the right backer and stain to bring the image to life.
Gabby
-
All patterns are very nice, thanks for your help.
-
Thanks for the time spent on the patterns,you guys do a great job. I will post pics when I get them cut.
-
I finished the pattern from JOLEET, thank you very much for the pattern.
-
Wow ;) Great job on the cutting, thanks for showing us....Ron
-
Wow willieg you did an amazing job cutting Ron's pattern. Well done guys.
Marg
-
Marg said it!
Gabby