Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: Des804 on August 11, 2013, 03:49:48 pm

Title: Coffin Bowlbox Pattern
Post by: Des804 on August 11, 2013, 03:49:48 pm

People have been asking me for the pattern so I thought I'd post it here.
I used 3/4 though if I try to do this exactly again I'll use 1/2 for the top part. 15 Degree angle on bottom 25 degree angle on top but here is the pattern.

Title: Re: Coffin Bowlbox Pattern
Post by: frankorona on August 12, 2013, 07:46:08 am

Thanks for sharing the pattern.