Scrollsaw Workshop Community -Please register to enable posting.

General Category => Pattern Requests. => Topic started by: newfie on July 06, 2013, 10:07:40 pm

Title: Christ or praying hands
Post by: newfie on July 06, 2013, 10:07:40 pm

looking for a pattern of Christ or praying hands for a cross i was asked to make for the graves of some relatives. i found a few but to much detail in them because the maximum width is 4 inches.any help is greatly appreciated.
Thanks 

Title: Re: Christ or praying hands
Post by: Merlin on July 06, 2013, 10:17:51 pm

Newfie: Here is one I done a couple weeks back, Jackrabbit was the designer.

https://www.filesanywhere.com/fs/v.aspx?v=8b6a69875c61757cb49a

***Merlin***

Title: Re: Christ or praying hands
Post by: Tomsunnu on July 07, 2013, 01:21:59 am

I made this in September of 2012, I hope this helps :)

Title: Re: Christ or praying hands
Post by: newfie on July 07, 2013, 08:00:43 am

there both nice but not what i'm looking for.i looking for a cut out i guess you can call i'm sure there's a proper name for it.the portrait style cutting wont work just nice something i can cut out and glue it on.

Title: Re: Christ or praying hands
Post by: jackrabbit7822 on July 07, 2013, 08:09:14 am

here is a pattern i use a lot hope it helps
jack
aka jackrabbit
aka sawdust

Title: Re: Christ or praying hands
Post by: EIEIO on July 07, 2013, 09:11:23 am

Newfie - this is a cut-out that maybe you can use. It's about 4.4" wide.
(https://lh4.googleusercontent.com/-h4oR--JMFmk/UXGSGEAYk7I/AAAAAAAAAlk/gb3NRg4c35M/w359-h563-no/StJoeFramed2.JPG)

Title: Re: Christ or praying hands
Post by: frankorona on July 07, 2013, 10:12:55 am

Beautiful patterns, thanks to all for your help.