Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: countryscroller on June 18, 2013, 09:36:01 pm

Title: Jesus Portrait
Post by: countryscroller on June 18, 2013, 09:36:01 pm

I made one with my own boarder for my dad for Christmas this past year, so I decided to make me one. Thanks in advance for any comments.  Thanks again to Old Crow for the pattern.

Title: Re: Jesus Portrait
Post by: EIEIO on June 18, 2013, 09:38:25 pm

Swell job, Dustin. Did you use a spiral or a flat blade?

Title: Re: Jesus Portrait
Post by: countryscroller on June 18, 2013, 10:03:47 pm

Thanks, I tried out my new UR #1 I got the other day. I have never used spiral before. 

Title: Re: Jesus Portrait
Post by: wombatie on June 19, 2013, 01:40:06 am

Fantastic job Dustin.

Marg

Title: Re: Jesus Portrait
Post by: DWSudekum on June 19, 2013, 06:24:45 am

Very nicely cut Dustin.  Thanks for sharing this one with us.

DW

Title: Re: Jesus Portrait
Post by: Danny on June 19, 2013, 06:27:55 am

Very Good Job there....Clean cuts and Don design is Great.
              Hey Dustin..........I learned from experience.  Hit n Miss thing about the
RIGHT blade to use.  Well if your cutting Pine, Popular or another soft wood the
UR#1 is MY ONLY BLADE OF CHOICE.    Even up to 3/4".  My 2 cents.  Danny :+}        

Title: Re: Jesus Portrait
Post by: frankorona on June 19, 2013, 07:37:07 am

Very nice job, looks great, thanks for sharing

Title: Re: Jesus Portrait
Post by: Russ C on June 19, 2013, 08:32:29 am

Looks fantastic, nice work. Thanks for sharing.  :)

Title: Re: Jesus Portrait
Post by: Tomsunnu on June 19, 2013, 10:01:14 am

Dustin , nicely done.
Mahendra

Title: Re: Jesus Portrait
Post by: newfie on June 19, 2013, 02:47:17 pm

nice work Dustin

Title: Re: Jesus Portrait
Post by: Marcellarius on June 22, 2013, 10:11:48 am

nice job, the carpenter made out of wood!

Title: Re: Jesus Portrait
Post by: mickey357 on June 22, 2013, 10:17:39 pm

Great job on the cutting.

Title: Re: Jesus Portrait
Post by: Al W on June 23, 2013, 10:52:11 am

Thanks for sharing.