Scrollsaw Workshop Community -Please register to enable posting.

General Category => Brag Forum => Topic started by: EIEIO on May 11, 2013, 11:22:18 pm

Title: Knife #3
Post by: EIEIO on May 11, 2013, 11:22:18 pm

OK - last knife posting for a while. This is #3 for the June 1 market. It is a longer drop point with a heavier blade and stainless trim rather than brass, finished with Purple heart scales. It has a guard, but not the protective finger guard like #1 and #2 had. The stainless tube in the lanyard hole is a lot harder to finish than the brass on #1 and #2. Grinding it down, it gets hot enough to burn the wood.

I shaped this handle, then buffed with red rouge - it makes a nice finish, but it looks less purple than when I started.
(https://lh4.googleusercontent.com/-yCrjXgJPTH4/UY8ILgbCCAI/AAAAAAAAAnM/2eAKMO5mFOQ/w677-h519-no/Knife+%25233.JPG)

Comments or recommendations are welcome.

Title: Re: Knife #3
Post by: Marcellarius on May 12, 2013, 08:46:10 am

very nice knife.

Title: Re: Knife #3
Post by: Al W on May 12, 2013, 08:49:46 am

Yep, another "knice" knife.   

Title: Re: Knife #3
Post by: frankorona on May 12, 2013, 10:19:08 am

Amazing work, looks perfect, knives you make are wonderful.
Thanks for sharing your talent

Title: Re: Knife #3
Post by: newfie on May 12, 2013, 10:23:02 am

another great looking knife.

Title: Re: Knife #3
Post by: Russ C on May 12, 2013, 10:50:51 am

Great job, really nice. Thanks for the pic.  :)

Title: Re: Knife #3
Post by: saggioculo on May 12, 2013, 03:38:39 pm

Such great work!  Great looking knife.