Scrollsaw Workshop Community -Please register to enable posting.
General Category => Pattern Requests. => Topic started by: thealley on April 29, 2013, 08:48:00 am
-
Hi,
Anybody knows where to find a 3D pattern for the above?
And if it exists, I guess you need to use special wood due to its round features, any suggestions pls?
Thanks.
-
How tall does the model need to be?
You could cut it as circles from 1 1/2" lumber (add fretwork frills on the outside) then stack them. The real dimensions look about like 183' tall x 54' wide, with each story about 20' tall. The 1st layer looks like a double height or about 40', so there are 9 stories. Using one thickness of 1.5" lumber per story would make a model 9*1.5" = 13.5" tall, width = 4".
Is that too small? You could double the story to 3", then total height=27", width=8".