Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: hardkore on March 03, 2013, 12:33:10 pm

Title: FONTS
Post by: hardkore on March 03, 2013, 12:33:10 pm

Steve,
I appreciate and enjoy your web site and you tube articles. I sometimes change the pattern to fit my use. One large problem that I had in the past is when I just want to change a word or two in your pattern. Usually I end up changing the font and normally use WordArt. However, it might really help if you could post the name of the font that you used originally.
Of course this all depends on the premise that you do not mind my altering your pattern.
Thanks for all of your help.

Title: Re: FONTS
Post by: Tomsunnu on March 04, 2013, 08:04:39 am

Hi, I think it is the COOPER BLACK font you are looking for :)
You will have more response from other members also on this subject.

Mahendra

Title: Re: FONTS
Post by: hardkore on March 05, 2013, 05:55:46 pm

Thanks, but I would like to duplicate the font the designer used. That way I  might have to only change one or two words rather than refonting the entire project. By the way I really enjoy using WordArt. It is a good looking font and cuts nicely with a scroll saw.

Title: Re: FONTS
Post by: dgman on March 05, 2013, 08:51:02 pm

Steve rarely comes here. If you want to talk to him directly send him an email. Go to his blog and click on the button that says "Email Me".