Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: frankorona on February 07, 2013, 07:18:13 pm
-
Hello I present this design by BoBscroll
Made with pine plywood 6mm.
hope you like it, thanks in advance by their comments
-
Very nice! Love the colors, what is that backing?
Pete
-
Very nice, Frank. I really like the colors in the backer.
Don R
-
Frank,looks very,very nice and colorful.
Mahendra
-
Very nice Frank. Thanks for sharing it with us. I love your colors.
DW
-
As always nice cutting. The colors are great, but the question on everyone's mind is, "What did you use for the backing?"
-
Looks fantastic Frank. The different colors really set it off. :)
-
Love it, love it, love. What more can I say.
Marg
-
great work Frank, and like everyone else asked, what did you use for the backing?
-
Hello, I used the same material, but I painted first with three basic colors, the colors are randomly placed, do not mix with each other.
I put the colors one by one leaving to dry the first to pursue the other.
Thank you for your comment.
-
great work Frank
-
Great work, I love the backer look. Thanks for sharing.
-
Muy bueno trabajo de Frank. Grandes colores tambi?n. Gracias por compartir la idea y trabajar con nosotros.
Very nice work Frank. Great colors too. Thanks for sharing the idea and work with us.
Al
-
nice job, really nice and colorful!
-
i really like it you did a great job with the backing it really stands out love it
-
Great work, looks fantastic, thanks for sharing.
-
Frank you did a great job on Bob's Pattern, love the backing.
Roly
-
Frank, came out nice and very colorful.....