Scrollsaw Workshop Community -Please register to enable posting.

General Category => General Scroll Saw Talk => Topic started by: geneVG on December 06, 2012, 10:10:17 pm

Title: clamp
Post by: geneVG on December 06, 2012, 10:10:17 pm

a while ago Steve tryed out a clamp for the 3D love you design he did, I think it is from Grizzly but not sure.  It is a clamo with two springs that hold the piece of wood in swhile you are cutting it.  Can someone help me with this?

gene

Title: Re: clamp
Post by: TheMelster on December 06, 2012, 10:19:25 pm

on the right top of this screen in Search...     type in clamp, recent posting for this topic appear.... scroll down to Love You post.

Title: Re: clamp
Post by: tundraguy on December 06, 2012, 10:31:56 pm

Look for my post on the 2nd page titled 3 d i love you and youl find what your looking for ....Jim..

Title: Re: clamp
Post by: daliclimbs on December 07, 2012, 08:18:00 am

Its made by Bigfoot products. Search for Bigfoot products compound cut jig and you should find it with no problems.

Title: Re: clamp
Post by: geneVG on December 07, 2012, 09:26:36 am

Thanks guys.

gene

Title: Re: clamp
Post by: dgman on December 07, 2012, 09:58:09 am

Hey Gene, Save your money, you can make your own jig! Check this out: http://www.stevedgood.com/3djig.pdf
Mine is simpler as it does not have the slots along the length of the rails.

Title: Re: clamp
Post by: newfie on December 07, 2012, 10:43:29 am

thats the same one i use,didn't put the slots in mine either and it works great.

Title: Re: clamp
Post by: Intarsia92 on December 07, 2012, 11:20:53 am

Here's a picture of the one I made, very simple and effective.

Title: Re: clamp
Post by: geneVG on December 07, 2012, 11:36:01 am

Hey Intarsia92,
What is the measerments of the pieces of wood you used?

gene

Title: Re: clamp
Post by: ChuckD on December 08, 2012, 12:06:23 am

I just use a 6 inch wood clamp with a couple of 1/4 inch scraps to protect it.  Works great, eZ on Ez off.  :)