Scrollsaw Workshop Community -Please register to enable posting.

General Category => Ask Steve a question. => Topic started by: steve KB9RDS on November 10, 2012, 07:40:21 pm

Title: Lifting arm for Dewalt 788 saw
Post by: steve KB9RDS on November 10, 2012, 07:40:21 pm

To Steve or anyone else.  On a video it was talked about a lifting arm for the Dewalt 788 saw.  Just bought a 788 and am teaching myself and my 10 yr old Granddaughter how to use it.  The lifting am in the video is 1 heck of a good idea and i would like to know where i could order one.  Thanks

Title: Re: Lifting arm for Dewalt 788 saw
Post by: dgman on November 10, 2012, 07:58:00 pm

Hey Steve, Welcome to the forum! Here is a link for the Jim Dandy Easy Lift: http://www.jimdandy.com/products.html. I used to use one on my DeWALT but quickly removed it because it just got in the way. If you learn to feed from the top, like the DeWALT was designed for, you will find you do not need it. If you bottom feed, it will work out for you.
Please go to the introduction page so we can welcome you properly!