Scrollsaw Workshop Community -Please register to enable posting.
General Category => Brag Forum => Topic started by: Dan26 on October 05, 2012, 09:06:48 pm
-
Well, thanks go out to a few people for this one. Crusty59 did one and I just had to give it a try. I used twine instead of leather to hole the portrait to the frame. Leather just wasn't cooperating. I also put a backer board and made the head a little smaller. I'm pretty satisfied with it. Comments and critiques welcome.
-
Really nice looking Dan. I personally prefer the look of leather, but I know the twine is a LOT easier to obtain and work with. I like the frame as well, very nice looking.
Well Done Dan, now I am going to want to do one as well, just have to locate the pattern. Thanks for sharing with us.
-
Al, this is a Steve Good pattern. Here's where you can find it: http://www.stevedgood.com/wolfminiclock.pdf (http://www.stevedgood.com/wolfminiclock.pdf).
-
nice work thanks for sharing
-
Very nicely done, Dan....
Good choices all around!
~~~GB~~~
-
I love it. One of my favorite projects I have seen on here!
-
Excellent work, love the frame too. But I agree with Al W that I prefer the look of leather rather than twine. But as he also said Leather is a lot harder to work with.
-
Dan, That is one great looking piece!!
-
Your Wolf Head came out very nice, I like it a lot.
-
Looks fantastic, a real nice job. Thanks for sharing. :)
-
Looks great, well cut.
Marg
-
Looks very nice, good job.
-
Great looking work!
-
Great looking work. I also like the frame a lot.
-
Very nice job, looks great....
-
Very nice job, looks great, thanks for sharing
-
very nice job,thanks for sharing